Mã lỗi máy in ricoh SP 3510SF

ERRO CODE SC 2xx máy in ricoh

Lỗi SC máy in ricoh

• Code: 202
• Description:Polygon motor on timeout error
  The polygon mirror motor does not reach the targeted operating speed within 10 sec. after turning.
• Causes:

• Code: 203
• Description:Polygon motor off timeout error
  The polygon mirror motor does not leave the READY status within 20 sec. after the polygon mirror motor switched off.
• Causes:

• Code: 204
• Description:Polygon motor lock signal error
  The signal remains HIGH for 200 ms (or 4times in 50msec polling) while the polygon mirror motor is rotating.
• Causes:Polygon motor/driver board harness loose or disconnected. Polygon motor/driver board defective. Laser optics unit defective. 1. Turn the main power off/on the machine. 2. Replace the interface harness of the laser optics unit. 3. Replace the laser optics unit.

• Code: 220
• Description:Beam Synchronize error
  The laser synchronizing detection signal for LD is not output within 400msec after the LD unit has turned on.
• Causes:Disconnected cable from the laser synchronizing detection unit or defective connection. Defective laser synchronizing detector. Defective LD. Defective ECB. 1. Check the connectors. 2. Replace the laser optics unit. 3. Replace the ECB.

• Code: 268
• Description:Laser Scanning Unit thermistor error
  At power on, the temperature sensor in the optics unit detected a temperature lower than -30°C for more than 4 sec. -or- It detected a temperature higher than 105°C for more than 1sec.
• Causes:Thermistor disconnected (causes extremely low temperature reading) Thermistor damaged and short circuited (causes extremely high temperature reading) 1. Turn the machine's main power off, and then on. 2. Replace the thermistor.

TRUNG TÂM DỊCH VỤ KỸ THUẬT BẢO TÍN

ĐC: 240 Nguyễn Văn Linh – TP. Hải Dương

ĐT: 0220 3891 366 Mobile: 0983.593.218 – 0168.55.88.111

web:suamayinhaiduong.net E-mail: mayin.haiduong@gmail.com

 Facebook: luongthanhthiep – fanpage: suamayinhaiduong.net